© 2011 LPKF AG HB V2.0/Dez-11 21
Pos: 6 /ED_Tech nische_Dokum entation/2_Bedi enungsanleitu ng/Maschine/RP _Fräsbohrplotter /ProtoMat_S_ Serie/ProtoMat_ S_Serie_IIG/ Kapitel_2_Sic herheitshinw eise/2_1_Gerätesich erheit @ 0\ mod_12544067 07494_2058.doc x @ 3552 @ 12 @ 1
2 Safety notes
The following chapter lists the most important safety notes for working with the
machine and the corresponding control software.
2.1 Device safety
Danger to life due to electrical shock!
Missing or inadequate electrical grounding may cause deadly
current strokes and/or fire.
The machine must operate connected with a tested protective
earth contact socket and the correct earthing must be checked.
Danger to life due to electrical shock!
Missing or inadequate electrical fuse protection may cause
deadly current strokes and/or fire.
Never bypass any fuses! Use only the fuses recommended by
the manufacturer.
Health hazard due to fine particle and gases!
During machining of work parts harmful fine particles and gases
may develop that can be inhaled!
Make sure that dust extraction is activated during machining of
the work piece. Use fine particle filters exclusively.
Risk of injury due to heavy load!
The machine is heavy and bulky, thus it cannot be carried, be
lifted or transported by only one person!
Lift and transport the machine always with two persons.
Risk of injury by unintended operations!
Any accidental starting of the motor and moving of the mill/drill
head during repairs and servicing may cause considerable
injuries.
Make sure that only one person operates the machine. Secure
the machine during servicing and repair activities appropriate.
To Next Page
Loading...
