© 2011 LPKF AG HB V2.0/Dez-11 23
Pos: 7 /ED_Tech nische_Dokum entation/2_Bedi enungsanleitu ng/Maschine/RP _Fräsbohrplotter /ProtoMat_S_ Serie/ProtoMat_ S_Serie_IIG/K apitel_2_Sic herheitshinw eise/2_2_Allgemei ne_Sicherheits hinweise @ 0 \mod_1254413 988782_2058. docx @ 3555 @ 2 @ 1
2.2 General safety notes
Observe any legal accident prevention and labour
protection regulations.
Observe the accident prevention and labour protection
regulations given by the employer or the industrial union.
Read the operation manual before start up the machine and
any usage of the machine. Contact the LPKF service if any
problems occur!
The machine must exclusively be operated, repaired and
serviced by qualified and authorised staff.
Please wear adequate work clothes respective protective
clothing when working at the machine.
Use the machine only according to intended usage.
Never operate the machine in an environment with danger
of fire or explosions.
Only operate the machine in proper condition. Make a
visual check before any usage and replace faulty cables
and tubes at once.
Only operate the machine with correct operating protective
devices.
Only operate the machine with tools and accessories
licensed by LPKF.
Perform the required service and repair procedure
according to the described periods.
Separate the machine from mains power supply whenever
you have to perform repairs or servicing.
Always remove damages or functional disturbances at the
machine at once. Put the machine out of service and secure
it against further usage whenever the damage cannot be
removed.
Remove dust and remains of material using a paint brush
or draw off any machining remains. Never use compressed
air to clean the machine!
Dispose of machining remains according to legal
regulations.
Make sure that your work space is always clean.
Always keep children away from the work space.
To Next Page
Loading...
