DLP-562: Detailed Level Procedure 363-206-285
Page 6 of 12 Issue 2, February 2000
DDM-2000 OC-3 MULTIPLEXER
11. Was response correct?
If YES, then proceed to Step 27.
If NO, then continue with Step 12.
12. Wait approximately 5 minutes for network to stabilize then repeat this
procedure from Step 7. If the second attempt to download software fails, then
do Trouble Clearing: TAP-116.Youmayhavetogototheremotesite.
13. STOP. YOU HAVE COMPLETED THIS PROCEDURE.
14.
NOTE:
The FE ID display on the remote SYSCTL must show one of the following
preceding software installation. Other conditions represent failure
conditions or conditions that will not allow a remote software download.
A. The letter "P." displayed in the FE ID display indicates corrupted
application software and you may be able to download software from
another shelf, or locally. Try again to download software from same
shelf. If there is no period after the "P", the software can only be
downloaded locally using the procedures of DLP-532.
B. Nothing displayed in the FE ID display indicates that compatible soft-
ware is installed in the OHCTL and SYSCTL and you may download
software remotely if remote software downloading is permitted for
this release.
Ensure PC is connected to the front CIT (CIT-1). If floppies are being used,
ensure the first (number 1) diskette is installed in floppy drive. If hard drive is
being used, ensure you are in the correct directory.
15. Enter term or term COMn command, where n = 1or2.Ifterm is entered
without the COMn option, then COM1 will be selected by default. If after starting
the terminal emulator you see the message Can’t find script <init>,
disregard it.
Response: Two brief messages are printed and you are instructed to
Press any key to continue...after the
second message. After you press any key, the terminal
emulator is loaded and the terminal responds as follows:
CTRM ready. (Type Alt-h for help.)
Communications established.
TAP-116
DLP-532
To Next Page
Loading...
Need help?
General
