Maeda LC1385M-8BF - Page 145

3-81
[4] DISPLAY SELECTION BUTTON (TIME)
On this machine, priority is given to the frequency display. When the frequency is being displayed, press
button (4) and the display will show the preset time for 5 seconds. After 5 seconds pass, the display
returns automatically to the frequency display. If any button other than TIME ADJ (H, M, ADJ) is pressed
within 5 seconds, the display returns to the frequency display.
For details of the method of adjusting the time, see “2.7.2 Method of Operating Mode [4] Setting Correct
Time”.
[5] AS/PS BUTTON
This button (5) actuates the auto store and preset scan function.
• Auto Store
If this button is kept pressed for at least 2 seconds during radio reception, it will automatically search for
6 available AM and FM stations each, starting with the lowest frequency and going up to the highest
frequency. These frequencies can then be saved in the preset memory.
• Preset Scan
If this button is pressed within 2 seconds, it is possible to select one of the already preset stations. Wait
for 6 seconds after pressing the button and then press the button again to select the next preset station.
If it is impossible to receive the preset frequency, the selection advances after 1 second to the next
preset station.
[6] PRESET STATION BUTTONS (1, 2, 3, 4, 5, 6)
If this button has been used to decide which stations to preset, it is possible to select the desired station at
a touch. It is possible to preset 6 stations each for both AM and FM.
For details of the method of presetting the stations, see “2.7.2 Method of Operating Mode [1] Method
Setting with Preset Button”.
NOTES
The preset button (6) can be used to save the frequency manually. To save the frequency
automatically,use the Auto store button (5).
[7] DISPLAY
This display (7) shows the reception band, frequency, press No., and time.
[8] TIME RESET BUTTON
Use this button (8) when adjusting the time.
For details of the method of adjusting the time, see “2.7.2 Method of Operating Mode [4] Setting Correct
Time”.
H: hour M: Minute ADJ: Sets to 00 minutes
[9] TUNING BUTTON (TUNING)
This button (9) is used to change the frequency.
For details of the method of tuning, see “2.7.2 Method of Operating Mode [2] Method of Tuning”.