4-66
5. Set a container to catch the oil under the drain plug under the
machine.
6. Using a handle, remove drain plug (P) and drain the oil.
7. Check the O-ring installed to plug (P), and if it is damaged,
replace the O-ring.
8. After draining the oil, tighten drain plug (P) securely.
Tightening torque: 58.8 to 78.4 Nm (6 to 8 kgfm)
9. Add the replacement amount of oil through oil filler (F).
10. Check that the oil level is between the H and L lines on the
sight gauge. For details of oil level check, See Operation 3.1.2
Checking Before Starting Engine [4] Checking/refilling Oil Level
in Hydraulic Tank”.
10.11 MAINTENANCE EVERY 8000 HOURS
Perform this maintenance in tandem with maintenance every 50/100/250/500/1000/2000/4000 hours.
[1] REPLACEMENT ENGINE HIGH-PRESSURE PIPING CLAMP
Please contact us or our sales service agency to have the engine high-pressure clamps replaced.
[2] REPLACEMENT FUEL SPRAY PREVENTION CAP
Please contact us or our sales service agency to have the fuel spray prevention cap replaced.
To Next Page
Loading...
