3-142
3.12 MACHINE INSPECTION AFTER DAILY WORK
3.12.1 BEFORE STOPPING ENGINE
Use the machine monitor to check engine coolant temperature (1),
engine oil pressure (2), and fuel level (3).
3.12.2 AFTER STOPPING ENGINE
1. Walk around the machine and check the crane, machine exterior, and undercarriage, also check for any
leakage of oil or coolant. If any problems are found, repair them.
2. Fill the fuel tank.
3. Check the engine compartment and battery around for paper and debris. Clean out any paper and
debris to avoid a fire hazard.
4. Remove any mud affixed to the undercarriage.
3.12.3 LOCKING
Always lock the following places.
(1) Door of operator‟s cab (Always remember to close the window.)
(2) Fuel tank filler port
(3) Engine hood
(4) Cover at rear of cab
(5) Battery room door
(6) Pump room door
(7) Door at front of tool box
To Next Page
