3-82
2.7.2 CONTROL OF RADIO
[1] METHOD OF SETTING WITH PRESS BUTTON
1. Press power switch (1) and display the frequency on display (7).
2. Use tuning button (9) to set to the desired frequency. There are
two methods for tuning: auto tuning and manual tuning.
3. With the display (7) showing the desired frequency, keep the
desired Preset button No. pressed for at least 1.5 seconds. The
reception sound will disappear, but when the presetting
operation (saving to memory) is completed, the sound will
appear again and the Preset No. and frequency will be shown on
the display to show that the presetting operation has been
completed.
4. After completing the presetting, press Preset button (6) and release it within approx. 1.5 seconds. This
will make it possible to receive the channel preset to that button. One channels each for AM and FM can
be preset to each Preset button.
It is also possible to save to the Preset button (6) by using the auto store button (5).
[2] METHOD OF TUNING
1. Press power switch (1) and display the frequency on display (7).
2. Use tuning button (9) to set to the desired frequency. There are two methods for tuning: auto tuning and
manual tuning.
• Manual tuning
Press tuning button (9) until the frequency is displayed on display (7).
Button: Frequency moves down
Button: Frequency moves up
When the frequency reaches the top or bottom frequency, it automatically continues as follows: Top →
Bottom, or Bottom → Top.
• Auto tuning
Press tuning button (9) for at least 3 seconds. When a station is picked up, the tuning automatically
stops. To search for the next station, press the tuning button again for at least 3 seconds.
Button: Frequency moves down
Button: Frequency moves up
If this button is pressed during auto tuning, the auto tuning will be cancelled and the setting will return
to the frequency in use before the button was pressed.
To Next Page
Loading...
