Maeda LC1385M-8BF - Page 147

3-83
[3] METHOD OF OPERATING MODE
• (BAS) Bass adjusting
When button (2) is pressed, BAS is displayed on display (7). If knob (1) is turned clockwise within 5
seconds, the bass sound is emphasized. If the knob is turned counterclockwise, the bass sound is
reduced.
• (TRE) Treble adjustment
When button (2) is pressed, TRE is displayed on display (7). If knob (1) is turned clockwise within 5
seconds, the treble sound is emphasized. If the knob is turned counterclockwise, the treble sound is
reduced.
• (BAL) Balance adjustment
When button (2) is pressed, BAL is displayed on display (7). If knob (1) is turned clockwise within 5
seconds, the sound from the right speaker is increased. If the knob is turned counterclockwise, the
sound from left speaker is increased. When it is set to BAL 0, the sound from the left and right speakers
is balanced.
NOTES
With each mode, the display is returned automatically to it‟s orignal setting after 5 seconds.
[4] SETTING CORRECT TIME
1. Press display selector button (4) and display the time on display
(7).
NOTES
After 5 seconds, the display (7) will return to the frequency
display and the time cannot be corrected. If this happens, press
display selector button (4) again.
2. Press time adjustment button (8) to select Hour or Minute.
Use the H, M, and ADJ buttons to set to the correct time.
• H button: Adjusts the hour (each time the button is pressed, the time advances by one hour)
If the H button is kept pressed, the time will advance continuously until the button is released.
• M button: Adjusts the minute (each time the button is pressed, the time advances by one minute)
If the M button is kept pressed, the time will advance continuously until the button is released.
• ADJ button: When the ADJ button is pressed, the time is reset as follows.
• When display is 00 to 05 minutes, time is returned to 00 min. 00 sec. (No change in hour)
• When display is 55 to 59 minutes, time is returned to 00 min. 00 sec. (Hour advances)
• When display is 06 to 54 minutes, time cannot be reset. (Time stays same)
Example: 10:05 → 10:00 10:59 → 11:00 10:26 → 10:26
[ANTENNA]
Before transporting the machine or putting it inside a building,
stored the antenna to prevent any interference.
Stow the antenna as flows.
1. Loosen antenna mounting bolt (1) and store the antenna at
position (A).
2. After storing the antenna, tighten bolt (1).