2-3
1.2 PREPARATIONS OF SAFETY OPERATION
PROVIDE SAFETY DEVICES FOR SURE
• Check that all guards, covers, mirrors and rear view camera are attached properly. Repair immediately
if damaged.
• Understand how to use the safety devices correctly and use properly.
• Do not detach any safety device under any circumstance. Keep control to achieve proper operation at
all times.
• Improper use of safety devices can lead to serious bodily accidents.
• Do not rely solely on safety devices.
• Carry out secure inspections and services, and be careful to
prevent accidents before they happen.
• Whenever you feel an abnormality of the Machine, abort working
immediately, ensure safety and report to the manager.
• Assign in advance who takes which solution to prevent secondary
accident.
• Do not drive the Machine when fuel or hydraulic oil is leaking from
the Machine. Report to the manager any abnormality, and fully
repair the fuel/hydraulic oil before use.
The fuel for this Machine is diesel oil. Be especially careful of any
fuel leak.
• Before leaving the Machine, lower the hoisted load to the ground,
stop the engine and pull out the engine key.
TEMPORARY STORAGE WHEN ABNORMALITY IS FOUND WITH MACHINE
In case the Machine is found with abnormality and is therefore stored
temporarily waiting for service, apply following measures to notify all
persons in the office that the use is prohibited due to failure.
• Indicate warning tags on the operation lever and other applicable
parts.
Write clearly the information such as abnormality contents, name
and contact of the storage manager, and the term of storage.
• Make sure the machine cannot move when parking by putting
blocks under the rubber tracks as pawls.
• Pull out the engine key and take it with you.
WEAR PROTECTIVE EQUIPMENT AND CLOTHES SUITABLE FOR WORK
• Always put on a helmet, safety shoes and safety belt.
• Select and make sure to put on necessary protective equipment
suitable for the relevant working condition.
• Do not wear loose garments or accessory items that may catch an
operation lever or protrusions and cause unexpected movement of
the Machine.