• When carrying out inspection and maintenance inside the door, always use the stopper to hold
the door open.
• Always keep the door locked except when opening it.
1. Release lock (1) of the door.
For details, see “Operation 2.14 Cap with Lock [2] Opening and
Closing Covers with Lock”.
2. Pull door lever (2) to release the lock.
3. Pull door (3) to open it, remove door support lever (4) from
spring catcher (5), then insert the L-shaped portion in the hole in
the frame.
4. To close door (3), lift up door support lever (4), fix it to spring
catcher (5) and close it.
5. Do not forget to lock the door.
2.20 OPERATION MANUAL STORAGE
A magazine box is provided on the left side of the operator‟s seat
for safekeeping the operation and maintenance manual.
Always keep the Operation and Maintenance Manual in this pocket
so that it is possible to read it at any time.
2.21 TOOL BOX
Open the door at the front of the tool box. The standard tool
compartment is inside.
Put the tools in the supplied hole at the end, and push the grease
gun holder fully in to store it.
To Next Page
Loading...
