3-123
5. When engine preheating monitor (4) goes OFF, turn the key in
starter switch (3) to the START position to start the engine.
6. When the engine starts, release the key in starter switch (3).
The key will automatically return to ON position.
7. Keep the engine idle for the initial 15 seconds right after it has
been started, and do not operate any control lever or the fuel
control dial during that time.
8. Check that the battery charge monitor (4), engine oil pressure
monitor (5), and engine oil level monitor (6) are OFF.
[Turbocharger Protect Function]
The turbocharger protect function is a function to protect the turbocharger by keeping the engine speed at
less than 1100 rpm immediately after the engine is started.
• When the turbocharger protect function is actuated, the engine speed is held at less than 1100 rpm,
regardless of the position of the fuel control dial.
• When the turbocharger protect function is actuated, the engine speed is held at less than 1100 rpm, even
if the fuel control dial is operated.
• When the turbocharger protect function is canceled, the engine speed is set to the speed for the position
of the fuel control dial.
• The relationship between the length of time of actuating the turbocharger protect function and the
temperature of the engine coolant is as shown in the table.
To Next Page
Loading...
