3-163
[6] DON’T USE FOR OTHER THAN MAIN APPLICATIONS
Do not move people up/down with the crane.
[7] DON’T PERFORM UNREASONABLE OPERATIONS
Operations requiring more than the machine performance can
cause accidents.
Particularly, crane operations must be carried out according to the
rated total load chart.
[8] DON’T WIND WIRE BY FORCE
Be careful not to hook the wire rope over a tree or steel beam while
working.
If it gets stuck with something, do not force by winding the wire.
Untangle and then wind the wire.
[9] DON’T OPERATE HOIST DURING TRAVELING
Pick and carry operations are very dangerous and may cause
shaking of the hoisted load or overturning of the machine. Thus, it
should be prohibited in general. Where such an operation is
un-avoidable, refer to "Operation 3.25 Pick & Carry Operation" and
strictly observe the safety precautions in it.
[10] NO OPERATIONS ON SLOPE
Crane operation on a slope may cause the machine to turn over.
Basically do not implement crane operation on a slope. If you
absolutely have to do it, place some earth fill (B) on the slope to
make the ground leveled and hard, to prevent the machine from
turning over, then place the machine on the ground.
Always check that the machine is level using the level gauge on
the left side of operator‟s seat.
To Next Page
Loading...
