Maeda LC1385M-8BF - Page 275

4-15
Inspection and maintenance item
Page
10.3 MAINTENANCE EVERY 50 HOURS
4-35
[1] GREASING MACHINE UNITS
4-35
10.4 MAINTENANCE EVERY 100 HOURS
4-37
[1] CHECKING/REFILLING OIL IN SWING MACHINERY CASE
4-37
10.5 MAINTENANCE EVERY 250 HOURS
4-38
[1] CHECKING/REFILLING OIL IN TRAVEL MOTOR REDUCTION GEAR CASE
4-38
[2] CHECKING/REFILLING OIL IN WINCH MOTOR REDUCTION GEAR CASE
4-39
[3] CHECKING LEVEL OF BATTERY ELECTROLYTE
4-40
[4] CHECKING/ADJUSTING COOLING FAN BELT TENSION
4-42
[5] CHECKING/ADJUSTING AIR COMPRESSOR BELT TENSION
4-43
10.6 MAINTENANCE EVERY 500 HOURS
4-44
[1] GREASING BLADE EACH SECTION
4-44
[2] REPLACEMENT ENGINE LUBRICATING OIL AND OIL FILTER CARTRIDGE
4-45
[3] REPLACEMENT FUEL PRE-FILTER CARTRIDGE
4-46
[4] CHECKING SWING PINION GREASE LEVEL, ADDING GREASE
4-48
[5] GREASING SWING CIRCLE
4-48
[6] CLEANING EACH COOLER FINS AND A/C CONDENSER FINS
4-49
[7] CLEANING AIR CONDITIONER FRESH/RECIRC FILTERS
4-50
[8] REPLACEMENT BREATHER ELEMENT IN HYDRAULIC TANK
4-51
[9] REPLACEMENT OIL IN WINCH MOTOR REDUCTION GEAR CASE
Only the first maintenance of a new machine
4-52
10.7 MAINTENANCE EVERY 1000 HOURS
4-53
[1] REPLACEMENT OIL IN SWING MACHINERY CASE
4-53
[2] REPLACEMENT OIL IN TRAVEL MOTOR REDUCTION GEAR CASE
4-54
[3] REPLACEMENT OIL IN WINCH MOTOR REDUCTION GEAR CASE
4-55
[4] REPLACEMENT HYDRAULIC OIL FILTER CARTRIDGE
4-56
[5] REPLACEMENT FUEL MAIN FILTER CARTRIDGE
4-57
[6] CHECKING/REFILLING OIL IN PTO GEAR CASE
4-59
[7] CHECKING ALL TIGHTENING POINTS OF ENGINE AIR INTAKE PIPE CLAMPS
4-59
10.8 MAINTENANCE EVERY 2000 HOURS
4-60
[1] CLEANING HYDRAULIC TANK STRAINER
4-60
[2] CHECKING ALTERNATOR AND STARTER MOTOR
4-60
[3] CHECKING/ADJUSTING ENGINE VALVE CLEARANCE
4-60
[4] CHECKING CHARGE PRESSURE OF NITROGEN GAS IN ACCUMULATOR
4-61
10.9 MAINTENANCE EVERY 4000 HOURS
4-63
[1] CHECKING WATER PUMP
4-63
[2] REPLACEMENT ACCUMULATOR
4-63
[3] CHECKING FOR LOOSENESS OF HIGH-PRESSURE PIPING CLAMP
4-63
[4] CHECKING FOR MISSING FUEL SPRAY PREVENTION CAP
4-64
10.10 MAINTENANCE EVERY 5000 HOURS
4-65
[1] REPLACEMENT OIL IN HYDRAULIC TANK
4-65
10.11 MAINTENANCE EVERY 8000 HOURS
4-66
[1] REPLACEMENT ENGINE HIGH-PRESSURE PIPING CLAMP
4-66
[2] REPLACEMENT FUEL SPRAY PREVENTION CAP
4-66