4-62
5. Set the lock lever to the FREE position (F).
6. Operate the blade control lever fully to the LOWER position.
7. Check that the blade goes down to the ground under its own
weight.
This completes the inspection.
If the nitrogen gas charge pressure in the accumulator is low and operations are continued, it
will become impossible to release the remaining pressure inside the hydraulic circuit if a failure
occurs on the machine.
In these following causes, the charge pressure of the accumulator has gone down. Please
contact us or our sales service agency.
• Blade does not go down.
• Stop while going down.
To Next Page
Loading...
