Maeda LC1385M-8BF - Page 381

6-41
9.2 MAINTENANCE EVERY 50 HOURS
[1] GREASING
CAUTION
• Grease a new machine regularly until it has been operated for 100 hours, that is the time when
the machine will have settled down and may be considered as run-in.
• Any unusual noise at greasing points requires immediate greasing regardless of the
maintenance period.
Use a grease type in the following table depending on the greasing point.
No.
Greasing Point
Grease Type
1
Hook block greasing
2 Places
Lithium grease
2
3
Fly-jib angle adjusting outer rod pin greasing
1 place
4
Fly-jib angle adjusting inner rod pin greasing
1 place
5
Fly-jib mounting boss greasing
(Greasing when installed fly-jib)
2 Places
6
Fly-jib foot pin greasing
1 place
1. Grease, by using a grease pump, to the grease fitting indicated
with an arrow.
2. Cleanly wipe off the old grease that was pushed out after
greasing.