EasyManua.ls Logo

Maeda LC1385M-8BF - Page 49

Default Icon
384 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
2-29
USE APPROPRIATE TOOLS
Use only tools suited to the task and be sure to use tools correctly.
Using damaged, low quality, faulty, makeshift tools improper use of
the tools could cause serious personal injury.
PRECAUTIONS FOR ELEVATED WORK
For elevated work, prepare an appropriate elevated work platform with steps.
CAUTION WHEN WORKING UNDER THE MACHINE NAD CRANE
• Hoists or jacks used to lift the machine up must be capable to carry
on the weight of the component and be in a good condition, as well.
In addition, avoid using a hydraulic jack to lift up the damaged, bent
or twisted part of the machine. Also, the wire rope for hoisting should
be the one without any wire breakage, decreasing in the diameter
and/or kink. Avoid using bent or damaged hooks.
•If it necessary to go under the crane or the machine to carry out
service and maintenance, support the crane and machine securely
with blocks and stands strong enough to support the weight of the
crane and machine.
Avoid using concrete blocks to support the machine. Concrete
blocks easily crush even in small loads.
CLEAN BEFORE INSPECTION OR MAINTAIN
Before starting an inspection or maintenance, clean the Machine
and prevent rubbish from entering the Machine and make sure the
safety will be ensured during maintenance.
Attempt to inspect or maintain with the maintenance Machine still
dirty not only lessens chance of locating faulty part, but may cause
rubbish or mud entering your eye, or slipping and tripping resulting
in injury.
Always observe followings when washing the vehicle.
Use anti-slip shoes to prevent slips and trips caused by wet
foothold.
Put on protective equipment when using a high pressure steam car
wash. Avoid the accidents that the contact with high pressure
water causes such as skin laceration or mud or other substances
flying into eye.
Do not directly spray water onto electrical system (sensors,
connector (1), receiving box and related). Entrance of water into
the electrical system causes faulty operations and may trigger
improper operations, thus is dangerous.

Table of Contents

Related product manuals