Magnetek IMPULSE VG+ Series 3 User Manual

IMPULSE•VG+ Series 3 Instruction Manual – 07/25/05
5-91
C 2037 2145-FVG+S3
D 2045 Not Used
E 2055 2215-FVG+S3
F 2075 2283-FVG+S3
10 2090 2346-FVG+S3
20 40P4 4001-FVG+S3
21 40P7 4002-FVG+S3
22 41P5 4003-FVG+S3
23 42P2 4005-FVG+S3
24 43P7 Not Used
25 44P0 4008-FVG+S3.
26 45P5 4012-FVG+S3
27 47P5 4017-FVG+S3
28 4011 4024-FVG+S3
29 4015 4031-FVG+S3
2A 4018 4039-FVG+S3
2B 4022 4045-FVG+S3
2C 4030 4060-FVG+S3
2D 4037 4075-FVG+S3
2E 4045 4091-FVG+S3
2F 4055 4112-FVG+S3
30 4075 4150-FVG+S3
31) 4090 4180-FVG+S3
32 4110 Not Used.
33) 4132 4260-FVG+S3
34 4160 4304-FVG+S3
35 4185 4370-FVG+S3
36 4220 4477-FVG+S3
37 4300 4590-FVG+S3
O2-05 Operator M.O.P Selects whether the ENTER key is
used when the frequency reference is
set by the digital operator. The digital
operator can simulate a motor
operated potentiometer (M.O.P.) by
setting this parameter.
0Adv
0 Disabled ENTER Key Required Note: This feature cannot be used in
conjunction with infinitely variable
speed control.
1 Enabled ENTER Key Not Required
O2-06 Oper Detection If the digital operator is disconnected
from the inverter. This parameter
selects whether the inverter detects
this condition. The operator is only
detected when the inverter is being
commanded locally.
1Adv
0 Disabled
1 Enabled
O2-07 Elapsed Time Set Viewable by U1-13 0–65535 0 Adv
O2-08 Elapsed Time Run Defines the operation time that
accumulates in the timer.
1Adv
0 Power-On Time
1 Running Time
O2-10 Fan ON Time Set Sets the initial fan operation timer
value displayed in U1-40
0-65535 0 Adv

Magnetek IMPULSE VG+ Series 3 Specifications

General

Brand	Magnetek
Model	IMPULSE VG+ Series 3
Category	Controller
Language	English