Magnetek IMPULSE VG+ Series 3 User Manual

IMPULSE•VG+ Series 3 Instruction Manual - 07/25/05
2-4
IMPULSE•VG+ Series 3 System Components And External Devices
Standard IMPULSE•VG+ Series 3 Drive Components
• PG-T2 Encoder Card
Optional Drive Components
• G5IN4 Control Input Card
• D0-08 Control Output Board
• D0-02 Control Output Relay Board
• AI-14B Analog Input Card
As-Required Drive Components
• AC reactor—line or load
•DC bus reactor
• External dynamic braking resistor(s)
• External dynamic braking unit
Required External Devices
•Motor
• User input device (pendant, joystick, PC, PLC, radio, or infrared control)
• External circuit protection devices (fuses or circuit breakers) (See “Suggested Circuit Protection
Specifications and Wire Size” in Chapter 3.)
• R-C surge suppressors on contactor coils

Magnetek IMPULSE VG+ Series 3 Specifications

General

Brand	Magnetek
Model	IMPULSE VG+ Series 3
Category	Controller
Language	English