Manitowoc 16000 User Manual

Reference Only
Manitowoc Published 05-03-17, Control # 228-03 1-13
16000 SERVICE/MAINTENANCE MANUAL INTRODUCTION
1
DESCRIPTION OF CRANE OPERATION
See Figure 1-7.
This section describes the standard and optional equipment
available for the Model 16000 crane. Disregard any
equipment your crane does not have.
The operating system is an EPIC

(Electrical Processed
Independent Control) with CAN-bus (Controller Area
Network) technology. The CAN-bus system uses multiple
nodes that contain remote controllers. The remote node
controllers communicate with Node-1 master controller by
sending information data packets over a two-wire bus. The
data packets are tagged with addresses that identify each
system component.
With the CAN-bus system, the independently powered
pumps, motors, and cylinders provide controller-driven
control logic, pump control, motor control, on-board
diagnostics, and service information. Crane information is
shown on the main display in the operator cab (see Main
Display topic in Section 3).
A diesel engine provides power to operate the system
pumps through a pump drive transmission.
In a closed-loop hydraulic system, high-pressure hydraulic
fluid from the system pump drives a hydraulic motor or
cylinder. Pressure develops within the closed-loop system
while resistance to movement of the load on the motor or
cylinder is overcome. When movement begins, pump
volume displacement maintains motor speed or cylinder
movement. The spent hydraulic fluid from the motor outlet
returns to the pump input. The crane closed-loop systems
are swing, right travel, left travel, the boom/mast hoist, and
the load drums.
Enabled means hydraulic fluid can flow in a system or an
electrical component is on. Disabled means hydraulic fluid
is blocked in a system or an electrical component is off.
Each hydraulic solenoid valve is assigned an HS number for
identification in this section.
FIGURE 1-7
Control Signal
(Pump Stroke)
Control
Handle
Pressure
Feedback
Node 2
Motor Speed
Feedback
Node 1
Master Controller
Handle
Command
Signal
Swashplate
Position
Control Signal
(Motor Stroke)
Hydraulic
Motor
Suction
Manifold
Charge
Pump
High Pressure
Side
Low Pressure Side
Hydraulic
Piping
Node 3 Node 4
Node 5
Node 20 Node 21
Electronic
Displacement
Control (EDC)
Pressure
Control Pilot
(PCP)
Hydraulic
Pump
Drum
Line Legend (For Colored Figures)
High-pressure Hydraulic, Positive Electrical
Negative Electrical (Ground)
Low-pressure Hydraulic, Signal Electrical
Control Or Pilot Pressure Hydraulic
Case Return Pressure Hydraulic
Not Active Line Or Circuit
Node 6
16-1001
Node 7

Manitowoc 16000 Specifications

General

Brand	Manitowoc
Model	16000
Category	Construction Equipment
Language	English