Manitowoc Grove TMS9000-2 Series - Page 159

Grove Published 02-21-2019, Control # 611-05 3-95
TMS9000-2 OPERATOR MANUAL OPERATING CONTROLS AND INDICATORS
3
Extend/retract outrigger beams
1. To extend or retract an outrigger beam or jack, select the
beam/jack with the jog dial or control panel. (Left rear
beam is selected and beam icon is green, meaning it is
active).
2. Press and hold the extend/retract switch (1,
(Figure 3-116)) on the left hand control panel.
Release the switch when the extension/retraction is reached.
Extend/retract outrigger jack cylinders
1 Front left (Figure 3-115)
2 Front right
3 Rear left
4 Rear right
5 Center front
6 Auto level
FIGURE 3-115
8854-100a
1
2
3
4
5
6
1 Front left (Figure 3-117)
2 Front right
3 Rear left
4 Rear right
5 Center front
6 Auto level
FIGURE 3-116
8854-100a
1
FIGURE 3-117
8854-101a
1
2
3
4
5
6