Grove Published 02-21-2019, Control # 611-05 3-133
TMS9000-2 OPERATOR MANUAL OPERATING CONTROLS AND INDICATORS
be used to select it. Then, when the check-mark is used on
this screen, the new requested telescoping status will be
used and the semi-automatic telescoping function
commences. The ODM (operating display) can then be used
to select a telescoping screen and the requested telescoping
status should be shown on the ODM, as well.
Note that when the RCL configuration screen is used (such
as shown in Figures 3-199 and 3-200), the telescoping
function is paused (unable to extend, retract, lock or unlock
the boom). Once the check-mark is used, the telescoping
function resumes.
To Next Page
Loading...
