OPERATING CONTROLS AND INDICATORS TMS9000-2 OPERATOR MANUAL
3-134 Published 02-21-2019, Control # 611-05
Outrigger span display
Necessary outrigger span (Figure 3-201) for the displayed
RCL code – display in percent (%) – Enter outrigger span,
page 3-130
Display of the lattice extension offset angle
When the RCL is programmed for a lattice extension, the
lattice extension offset angle (current angle between the
lattice extension and main boom in degrees) will be
displayed.
Current main boom angle display
Current swing angle display
Current load display
Tare Functionality/Instructions
Display:
Current angle between main boom and
horizontal position in degrees (°) (2,
(Figure 3-202))
0°:
Position 0° to the rear (3,
(Figure 3-202))
180°: Position 180° to the front
+0.1 to +180.0°: Turned to the right from 0°
-0.1 to -179.9°: Turned to the left from 0°
Display:
Lifted load (1, (Figure 3-203)) in tons (t) or
kilo-pounds (klbs)
Example: 5.95 klb equals 5,950 lbs.
Display:
The Actual Load is 1.4klb, if you set the Tare
Value to 1.2klb, the Actual Load would then be
displayed as 0.2klb.
To Next Page
Loading...
