4-7
TMS9000-2 OPERATOR MANUAL OPERATING PROCEDURES
Published 02-21-2019, Control # 611-05
The fan also switches on with the heater in order to avoid
overheating.
Temperature
You can preselect a temperature. The preselected
temperature is automatically set and maintained.
To increase the temperature
Turn the knob (2, Figure 4-2) clockwise.
To reduce the temperature
Turn the knob (2) counterclockwise.
Fan
You can set the air volume that is delivered to the
superstructure cab.
Increasing the air volume
Turn the switch (10, Figure 4-2) clockwise.
The switch engages in three different positions.
Reducing the air volume
Turn the switch (10) counterclockwise.
When the heater is switched on the fan comes on at slow
speed.
Fresh air/recirculated air
You can set which air is sucked in by the heating system.
Fresh air
Press the button (8, Figure 4-2) – lamp goes out.
Recirculated air
Press the button again – lamp illuminates. Only the
superstructure cab air is extracted.
Air distribution
You can make the heating air flow from the different air vents.
Air vents on the windshield and in the center
Turn the switch (11, Figure 4-2) clockwise.
To Next Page
Loading...
Need help?
General
