Manitowoc Grove TMS9000-2 Series - Page 255

4-45
TMS9000-2 OPERATOR MANUAL OPERATING PROCEDURES
4
Published 02-21-2019, Control # 611-05
GROVE
• Confirm the selection.
Direction arrows appear on the display.
Input mode is switched on.
Selecting values
With the input mode switched on, you can select values that
are permissible according to the Lifting Capacity Table.
The selection process is described using reeving as an
example.
• Select and confirm the symbol (1, Figure 4-50) – arrows
on the left and right are displayed.
• Select using the left or right buttons on the control panel
until the display shows the rigged reeving.
• Confirm the selection.
The display (2) shows the corresponding RCL code.
You can cancel the input at any time. Press button (1,
Figure 4-51) or (2).
After the selection procedure, there are three options:
• Cancel input mode:
- Press the button (3, Figure 4-52) or (4) once – the
config menu is opened.
• Switching over the input mode:
- Select and confirm a symbol (1) for the next
component – symbol red.
• Accept the displayed rigging mode:
- Select and confirm the symbol (2), refer to
Accepting the rigging code, page 4-48.
Enter the other components of the current rigging mode in
the same way.
Counterweight
• Select and confirm the symbol (1, Figure 4-53).
8849-28a
FIGURE 4-49
1
1
1
2
3
4
8882-28a
FIGURE 4-50
1
2
8849-31
FIGURE 4-51
8849-32a
FIGURE 4-52
8882-28a
1
2