Manitowoc Grove TMS9000-2 Series - Page 256

OPERATING PROCEDURES TMS9000-2 OPERATOR MANUAL
4-46
Published 02-21-2019, Control # 611-05
• Use the buttons (2) or (3) to select the required
counterweight combination, e.g. 21.0 klb.
• Confirm the selection.
Boom system
• Select and confirm the symbol (1, Figure 4-54).
• Use symbol (1, Figure 4-54) to select the rigged boom
system.
• Confirm each selection.
Outrigger span display
Depending on the equipment of the truck crane, the outrigger
span (Figure 4-55) is shown in meters, feet or percent (%).
Outrigger span
• Select and confirm the symbol (1, Figure 4-55).
• Use the buttons (2) or (3) to select the rigged outrigger
span.
• Confirm the selection.
• Press the extend/retract button (1, Figure 4-56) to
deploy the outriggers to the desired position.
8849-33a
FIGURE 4-53
8882-28b
1
1
FIGURE 4-54
5
8882-28a
2
3
4
1
2 Main boom
3 Main boom with lattice extension
4 Angle of the manual lattice extension
5 Length of lattice extension
9084-1
FIGURE 4-55
1
8849-36a