Manitowoc Grove TMS9000-2 Series - Page 273

4-63
TMS9000-2 OPERATOR MANUAL OPERATING PROCEDURES
4
Published 02-21-2019, Control # 611-05
GROVE
Assignment for display
The CCS display shows a sectional view of the main boom in
the menus.
The following elements are displayed (Figure 4-115):
Fixed length, intermediate length, telescoping length
There are lifting capacity tables for main boom fixed lengths,
main boom intermediate lengths and main boom telescoping
lengths.
The lengths are automatically detected by the RCL, and the
corresponding lifting capacities according to the Lifting
capacity table are enabled and displayed automatically.
Main boom fixed length
Main boom fixed lengths have the greatest lifting capacities.
A main boom fixed length is reached if:
- All telescopic sections are locked to a fixed length
- All telescopic sections are set down.
0 Base section
1 Telescopic section I
2 Telescopic section II
3 Telescopic section III
4 Section locking pin on the telescopic section
5 Cylinder locking pins on the telescoping cylinder
6 Section pin cutouts (holes)
7 Cylinder pin engagement cutouts (holes)
9093
FIGURE 4-115