SUPPLEMENTAL SERVICE INFORMATION, INTAKE-AIR SYSTEM
SUPPLEMENTAL SERVICE
INFORMATION
• The following additions have been made since
publication of the Mazda 626 Workshop Manual
Supplement (1614-10-98D).
Accelerator pedal component
• Removal/Installation procedure has been added.
• Disassembly/Assembly procedure has been
added.
Accelerator position sensor
• Inspection procedure has been added.
• Adjustment procedure has been added.
Idle switch
• Adjustment procedure has been added.
Fully open stopper
• Adjustment procedure has been added.
PCM
• Inspection procedure has been added.
INTAKE-AIR SYSTEM
ACCELERATOR PEDAL COMPONENT
REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
4. Perform “IDLE SPEED INSPECTION” (See
Section F2.)
1
Accelerator position sensor connector
2 Accelerator pedal component
ACCELERATOR PEDAL
DISASSEMBLY/ASSEMBLY
1. Disassemble in the order indicated in the table.
2. Assemble in the reverse order of disassembly.
3. Perform “IDLE SPEED INSPECTION” (See
Section F2.)
1 Accelerator pedal
See F2-16, FULLY OPEN STOPPER
ADJUSTMENT
2
Idle switch
See F2-16, IDLE SWITCH ADJUSTMENT
3
Accelerator position sensor
See F2-16, ACCELERATOR POSITION
SENSOR ADJUSTMENT
F2-15
To Next Page
