DASHBOARD AND CONSOLE
CONSOLE DISASSEMBLY/ASSEMBLY
1. Disassemble in the order indicated in the table.
2. Assemble in the reverse order of disassembly.
6
1 Cup holder
2 Ashtray
3 Ring
4
Upper panel
5
Set panel
6 Boot
7
Bracket
1 Cup holder
2 Console lid lock
3 Console inner lid
4
Console lid stopper
5
Console lid
6
Ashtray
7
Bracket
CONSOLE ADJUSTMENT
Caution
• Take care to install the console and the
center panel so that there is not any
Interference which may cause noise.
1. Loosen screws A.
2. Slide the console indicated shown by the arrow
and measure the gap between the console and
the dashboard.
Clearance
a: 2.0—8.0 mm {0.08—0.31 in}
DASHBOARD SCREW A
3. Tighten screws A.
S-24
To Next Page
