SHIFT MECHANISM
SELECTOR LEVER DISASSEMBLY/ASSEMBLY
1. Disassemble in the order shown in the figure.
2. Assemble in the reverse order of disassembly.
1
Connector
See K2-58 Connector Disassembly Note
2 Screw
3
Selector lever knob component
4 Cover
5
Indicator panel
6
Selector illumination light
7
Cam
See K2-58 Cam Assembly Note
8
Selector lever
Connector Disassembly Note
1. Insert a thin metal from the terminal side of the
connector, and press down the terminal locking
tab.
THIN METAL
2. Pull the terminal out of the connector.
3. Clearance can be reduced by turning the cam
clockwise.
4. Install the selector lever knob and verify that the
clearance is as specified.
• If not as specified, repeat from Step 2.
5. Remove the selector lever knob.
Cam Assembly Note
1. Loosely install the cam to the push rod.
2. Adjust the clearance between the guide plate and
the guide pin by turning the cam.
K2-58
To Next Page
