AIR BAG SYSTEM
Connector Removal Note
• Slide the connector cover toward the harness and
then disconnect the connector from the side air
bag sensor.
Connector Installation Note
1. Attach the connector to the side air bag sensor.
2. Connect the connector by attaching it to the side
air bag sensor while lifting up the lock on the
connector with a flathead screwdriver.
Warning
• Handling the SAS unit Improperly can
accidentally deploy the air bag modules,
which may seriously injure you. Read AIR
BAG SYSTEM SERVICE WARNINGS before
handling the SAS unit. (See T-56 SERVICE
WARNINGS.)
1. Turn the ignition switch to LOCK position.
2. Disconnect the negative battery cable and wait for
more than 1 minute.
3. Remove the side walls.
4. Remove in the order indicated in the table.
5. Install in the reverse order of removal.
6. Turn the ignition switch to ON position.
7. Verify that the air bag system warning light
illuminates for approximately 6 seconds and
then goes off.
• If the air bag system warning light does not
operate in the manner described above, there
are malfunctions in the system. Inspect the
system using the on-board diagnostic.
Note
• When a new SAS unit has been installed, the
air bag system warning light flashes
continuously if there are no malfunctions in the
system. Perform the air bag module and
pre-tensioner seat belt deployment
authorization procedure. (See Section T.)
SAS UNIT BRACKET REMOVAL/INSTALLATION
1. Remove the SAS unit.
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
1 Nut
2 SAS unit bracket
T-59
To Next Page
Loading...
