AUDIO
AUDIO
POWER ANTENNA REMOVAL/INSTALLATION
Sedan, 5HB
1. Disconnect the negative battery cable.
2. Remove the trunk side trim.
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
1 Power antenna connector
2
Antenna jack
3
Mounting nut
See T-53 Mounting nut removal note
4 Spacer
5 Bolt
6 Power antenna
Mounting nut removal note
• Use snap-ring pliers to remove the mounting nut.
POWER ANTENNA DISASSEMBLY/ASSEMBLY
Sedan, 5HB
1. Disassemble in the order indicated in the table.
2. Assemble in the reverse order of disassembly.
1
Drain hose
2 Bracket
3
Harness
4
Ground plate
5
O-ring
6 Rod insulator
7 Motor
POWER ANTENNA INSPECTION
Sedan, 5HB
1. Remove the trunk side trim.
2. Disconnect the power antenna connector.
3. Connect ground to a bare metal part of vehicle
and terminal D of the power antenna.
4. Connect battery positive voltage to the following
terminal of the power antenna.
5. Verify that the power antenna operation is as
indicated below.
• If not as specified, replace the power antenna.
B+: Battery positive voltage
Terminal
Power antenna operation
A B
-
B+ Down
B+ B+
Up
n i5a n
D
*
B A
COMPONENT SIDE
CONNECTOR
(VIEW FROM
TERMINAL SIDE)
T-53
To Next Page
