SHIFT MECHANISM
3. Install the selector lever to the manual shaft lever
in such a way that the selector cable does not
bear a load.
4. Confirm that the end of the manual shift lever
sticks out of the end of the selector cable.
5. Install the selector cable to the selector cable
bracket.
SELECTOR CABLE
6. Verify that the selector lever to P position.
7. Unlock the lock piece of the selector cable
(selector lever side) in the order shown in the
figure.
8. Shift the selector lever from P position to L range,
and make sure that other components that area to
there is no interfere the lever.
K2-57
To Next Page
