ON-BOARD DIAGNOSTIC
STEP
INSPECTION
ACTION
9 VERIFY TROUBLESHOOTING OF DTC P071S
COMPLETED
• Make sure to reconnect all disconnected
connectors.
• Clear DTC from memory using NGS tester.
• Access VS PID using NGS tester.
• Drive vehicle with vehicle speed 40 km/h {25
mph} or above for 0.7 second or more
while monitoring PID.
• Is same DTC present?
Yes Replace PCM, then go to next step.
(See Section F1.)
No Go to next step.
10
VERIFY AFTER REPAIR PROCEDURE
• Perform “After Repair Procedure”.
(See K2-61 AFTER REPAIR PROCEDURE.)
• Is there any DTC present?
Yes Go to applicable DTC inspection.
No
Troubleshooting completed.
K2-81
To Next Page
