Mazda 626 - Page 340

ON-BOARD DIAGNOSTIC
Monitor item
(Definition)
Unit/
Condition
Condition/Specification Action
PCM
terminal
LINE
(Pressure control
solenoid)
A
ATF temperature at 60°C
{140°F}—70°C {158°F}
• Idle: 0.94—0.96 A
• Stall (D range): 0.25—0.35 A
• Stall (R range): 0—0.05 A
Inspect pressure control solenoid.
See K2-38 SOLENOID VALVES
INSPECTION
44, 81
RSW
(TR switch
[R range])
ON/OFF
R range: ON
Others: OFF
Inspect TR switch.
See K2-30 TRANSAXLE RANGE
(TR) SWITCH INSPECTION
32
SSW
(Transaxle range
switch [S range])
ON/OFF
S range: ON
Others: OFF
Inspect TR switch.
See K2-30 TRANSAXLE RANGE
(TR) SWITCH INSPECTION
9
SHIFT A
(Shift solenoid A)
%
Fourth gear: 99%
Others: 0%
Inspect shift solenoid A.
See K2-38 SOLENOID VALVES
INSPECTION
82
SHIFT B
(Shift solenoid B)
%
First gear: 99%
Others: 0%
Inspect shift solenoid B.
See K2-38 SOLENOID VALVES
INSPECTION
99
SHIFT C
(Shift solenoid C)
%
First gear: 99%
Second gear: 99%
Others: 0%
Inspect shift solenoid C.
See K2-38 SOLENOID VALVES
INSPECTION
102
SHIFT D
(Shift solenoid D)
ON/OFF
N or P position: ON
Others: OFF
Inspect shift solenoid D.
See K2-38 SOLENOID VALVES
INSPECTION
27
SHIFT E
(Shift solenoid E)
ON/OFF
Fourth gear at D range: ON
Others: OFF
Inspect shift solenoid E.
See K2-38 SOLENOID VALVES
INSPECTION
1
TEN
(TEN terminal
(in DLC))
ON/OFF
Terminal TEN (DLC) shorted to
GND: ON
Terminal TEN (DLC) open: OFF
Inspect wiring from DLC terminal TEN to
PCM terminal 1L.
5
THOP
(TP)
%
CTP: 0 %
WOT: 100%
Inspect TP sensor.
See Section F1
89
TR SW
(Load/no load
condition signal)
ON/OFF
N or P position: ON
Others: OFF
Inspect TR switch.
See K2-30 TRANSAXLE RANGE
(TR) SWITCH INSPECTION
64
TURBINE
(Input/turbine
speed signal)
RPM
Ignition switch ON: 0 rpm
Idle: 675—825 rpm
Inspect input/turbine speed sensor.
See K2-35 INPUT/TURBINE SPEED
SENSOR INSPECTION
23, 84
VS
(Vehicle speed)
KPH
MPH
Vehicle speed 20 km/h {12 mph}: 20
km/h {12 mph}
Vehicle speed 40 km/h {25 mph}: 40
km/h {25 mph}
ATX:
Inspect VSS.
See K2-36 VEHICLE SPEED
SENSOR (VSS) INSPECTION
58
K2-133