MCCORMICK MTX Series - Important Information for Eec Member States; Type Approval; Declaration of Conformity

Introduction
6
IMPORTANT INFORMATION FOR EEC MEMBER STATES
Type Approval
This tractor complies with the provisions of the following directive:
74/150/EEC - Type Approval
This tractor is road traffic law approved in all EC countries with this overall type approval, with designed
speeds up to 40 km/h.
Declaration of Conformity
This tractor meets the Electromagnetic Compatibility directive 89/336/EEC - and is marked with CE.
As an operator it is important to know the following:
EMC - Supplementary Information
Safety information for the supplementary installation of electrical and electronic appliances and/or
components.
This tractor is equipped with electronic constituents and component parts whose function can be influenced by
electromagnetic radiations of other appliances. Such influences can cause hazards for persons if the following
safety information is not taken into account.
1. For supplementary installation of electrical and electronic appliances and/or constituents on the tractor with a
connection to the onboard system, the user HAS to verify whether the installation causes disturbances to the
electronics on the tractor or other constituents. This particularly applies to the Hitch, PTO, Transmission Control and
the Instrument Cluster.
Also it has to be taken into account that the supplementary installed electrical and electronic components
comply with the EMC Directive 89/336/EEC in the respective current version and that they are CE marked.
2. For the supplementary installation of mobile communication systems (i.e. radio communication, mobile
telephone) the following additional requirements have to be fulfilled:
A. Only devices with an approval complying with the valid national regulations must be installed.
B. The devices must be firmly installed.
C. The operation of portable or mobile devices within the cab of the tractor is ONLY permitted if the device
has a fixed outside antenna.
D. The transmitting part shall be installed separately to the tractor electronics.
E. Installation of the antenna must be carried out by a professional and the antenna must have a good
ground connection between the antenna and the tractor ground.
For the correct size cabling, installation and the maximum permissible current supply, see your dealer.