Operation
137
5
Hitch Control Bypass
If the hitch should fail to operate properly and
there is a need to raise or lower the hitch in order
to travel home, the hitch controls can be
overridden by the UP/DOWN SWITCH.
To lower the hitch, move the UP/DOWN SWITCH
to the “Momentary” position and hold. Hitch will
drop for 1.5 seconds. Repeat the sequence until
the hitch is in the required position.
To raise the hitch, start with the UP/DOWN
SWITCH in the “Down” position, then move the
switch to the “Up” and then to the “Down”
position. The hitch will move up for 1.5 seconds.
Repeat the sequence until the hitch is in the
required position.
NOTE: If your tractor is equipped with rear
fender mounted remote hitch switches. They
can also be used to raise and lower the hitch.
To Next Page
Loading...
