Routine Maintenance
205
7
Check Transmission/Hydraulic
Oil Level
To check the transmission oil level, put the tractor
on level ground.
Make sure the dipstick (1) is pushed completely
in before checking the level.
MD03A008
If the oil level is below the NORMAL mark on the
dipstick, add the recommended oil in through the
fill tube (2) located at the rear of the
transmission.
MD04M081
If working in extreme hilly conditions make sure
the oil level is raised to the MAX mark on the
dipstick.
Check Coolant Level
MD04C140
Check the the coolant level within the reservoir is
within the normal cold range marks (1) on the
reservoir. If the level is below the lower mark, fill
the reservoir to the top mark with correct coolant
mixture, (this will depend upon market
requirements).
10 HOURS OR DAILY SERVICE
1
2
WARNING: DO NOT remove the
reservoir cap when the system is hot.
LET THE SYSTEM COOL. Hot coolant
can spray out resulting in scalding if the
cap is removed while system is still hot.
When checking the coolant level, turn cap
to first notch, then wait until pressure is
released. Scalding could result from fast
removal of the cap.
1
To Next Page
