MCCORMICK MTX Series - Parking the Tractor; Master Disconnect Switch

Operation
89
5
STOPPING THE ENGINE AND PARKING THE TRACTOR
STEP 1
Park the tractor. Once the tractors is stationary, put
the Forward/Reverse shuttle lever into the
NEUTRAL position.
STEP 2
Tractors with a Powershift Transmission
Put the Range lever in the NEUTRAL position.
STEP 3
Disengage the PTO if in operation.
STEP 4
Move the throttle lever fully rearward to the low
idle position for three to five minutes to decrease
the temperature of the engine and turbocharger,
before stopping the engine.
IMPORTANT: This procedure is very important if
the engine has been operating under heavy
load. It will allow the engine and turbocharger
temperature to decrease gradually.
STEP 5
Tractors with Independent Front Suspension
Fully lower the axle to the bottom mechanical stop.
STEP 6
Apply the Park Brake.
STEP 7
Turn the keyswitch to the Off position and remove
the key.
IMPORTANT: NEVER turn the keyswitch to the
Off position while the tractor is moving. Serious
damage to the transmission could result.
STEP 8
Turn off master disconnect switch (if equipped) and
remove the master switch key.
Folding Wheel Wedge
(If Equipped)
OM1401
Use the wheel wedge in front of or behind a rear
wheel, (depending on the direction of the tractor),
when parking the tractor on a slope.
IMPORTANT: To prevent accidents do not park
the tractor with equipment raised.
Master Disconnect Switch
(If Equipped)
MD05F175
Use the master disconnect switch to disconnect the
battery power from the electrical systems on the
machine, when leaving the tractor or during
servicing to prevent accidental start up.
The key can be removed to prevent unauthorized
use or accidents.
IMPORTANT: DO NOT, unless in an emergency,
use the master disconnect switch to stop the
engine.