Operation
154
REMOTE HYDRAULIC VALVES
MD04M079
Your tractor is equipped with a remote hydraulic
system which gives priority flow to the 1st remote
circuit. Flow will then be supplied to the 2nd, 3rd
and 4th remote circuits (as equipped).
The remote hydraulic control levers operate the
corresponding remote, e.g.; lever 1 controls
remote valve 1, lever 2 controls remote valve 2
etc.
DP96K097
NUMBERS 1, 2 AND 3 = REMOTE CONTROL LEVERS
NUMBER 4 = OPTIONAL 4TH REMOTE SWITCH
IMPORTANT: Implements and other attachments
can have several large remote cylinders that need
as much as 15 litres of fluid to fill. Always check the
transmission fluid level after charging cylinders of
implements and attachments. Never operate the
tractor under load if the fluid level is low.
IMPORTANT: Under "normal" operating
conditions the maximum oil available for
external use is:
1. Stationary tractor operating on slopes
of no more than 2 degrees.............. 30 litres
(7.9 US gal)
2. Moving tractor operating on slopes
of no more than 15 degrees ........... 20 litres
(5.3 US gal)
3. Moving tractor operating on slopes
of no more than 30 degrees ............ 12 litres
(3.2 US gal)
If the tractor is to be operated under extreme hilly
conditions or where an implement requires more
oil, up to an additional 12 litres of oil can be
added to the transmission. This additional oil will
then increase the above quantities by 12 litres
(3.2 US gal) respectively.
The return hydraulic oil from all implements must
be returned through the hydraulic couplers on the
remote valves to prevent damage to the
transmission. The return oil supplies pressure
lubrication to the transmission.
1
2
3
4
To Next Page
Loading...
