Operation
90
POWERSHIFT TRANSMISSION OPERATION
The Powershift transmission is operated with the
forward/neutral/reverse lever, the range lever, and
the powershift switch located on the knob of the
range lever.
NOTE: In ambient temperatures of -10°C or below,
the transmission and controls could be difficult to
operate for the first few minutes after starting, until
the transmission oil is warm.
Selecting Speeds with Tractor
Stationary
STEP 1
DP96J337
Move the powershift switch to position 1.
STEP 2
DP96J336
Push the clutch pedal fully down and select the
range. Disengage the park brake.
STEP 3
MD04C021
Select FORWARD or REVERSE and slowly
release the clutch pedal. The tractor will start
moving.
IMPORTANT: The FORWARD/NEUTRAL/
REVERSE lever must only be moved with the
operator sitting on the seat. If the lever is
moved without the operator sitting on the seat
the tractor will not move. The operator must
sit on the seat and move the lever back into
NEUTRAL and then into FORWARD to start
the tractor moving.
To Next Page
Loading...
