Safety Precautions
15
2
Tractor Warning Lamp Usage
Rest Of World Tractors
● The flashing amber warning lamps must be
used according to local road traffic laws.
DP97A095
The amber warning lamps are used to indicate a
hazard to other road users. To operate, press the
switch (1) as shown above. This operates all four
direction turn indicator lamps at once.
IMPORTANT: When operating the tractor, towing
an implement or trailer, the complete rear area
warning system (amber warning lamps, when
applicable, and red tail lamps) must be easily seen
by any vehicle operator coming near the tractor.
Implement Warning Lamps
(If Equipped)
It is recommended that implement warning lamps
are used:
● If the flashing warning lamps and red tail lamps
on the tractor cannot be seen because they are
obstructed by the implement.
● If the towed implement is 1219 mm or more
behind the hitch point of the tractor.
● If the towed implement is 1219 mm or more to
the left or right of the center of the tractor.
● If the towed implement is 3000 mm or more
wide.
Install the warning lamps to indicate the side of the
implement nearest the centre of the road.
Rotating Amber Beacon (If Equipped)
● The rotating amber beacon must be used
according to local road traffic laws.
DP97A095
The rotating amber beacon is operated by pressing
the switch (2) with the flashing beacon symbol.
Slow Moving Vehicle Symbol
(If Equipped)
● For correct use of the SMV symbol (3),
observe local road traffic laws.
MD04M077
If a Slow Moving Vehicle (SMV) symbol is equipped
it must be installed on the rear part of the tractor.
To install the SMV symbol on an implement or trailer
a special bracket must be obtained from your dealer.
1
WARNING: Collision of high speed road
traffic and slow moving machines can
cause personal injury or death. On roads,
use amber warning lamps according to
local laws. Keep SMV emblem visible. Pull
over to let faster traffic pass. Slow down
and signal before turning off.
2
3
To Next Page
Loading...
