Routine Maintenance
225
7
Service Engine Air Filter
STEP 1
MD03D112
Release the cover retaining clips and remove the
cover.
STEP 2
MD03D112
Pull out the primary (outer) filter element.
STEP 3
MD03D112
Pull out the secondary (inner) filter element, if it
is to be changed.
IMPORTANT: DO NOT remove the secondary
(inner) element unless it is to be changed.
STEP 4
Clean the inside of the filter body.
IMPORTANT:
Dispose of filters correctly in
accordance with local regulations. Be
responsible for the environment.
STEP 5
Install a new secondary (inner) element, if
necessary or after the third cleaning of the
primary filter. Apply talcum powder or similar to
the inner seal face before installing the filter.
Install with closed end outwards.
NOTE: NEVER use a petroleum base lubricant
on the seal area. Petroleum lubricant could
“glue” the cover to the element seal and
damage the element.
1000 HOUR MAIN SERVICE
To Next Page
Loading...
