MCCORMICK MTX Series - Page 260

Technical Specfications
252
Remote Hydraulic System
Pump ............................................................................. Axial Piston Pump, Pressure and Flow Compensated
Remote Valve.......................................................... Closed Center, One to Four Sections, 1st Section Priority,
with Load Check on ‘B’ Port, (Raise)
Variable Flow Control for Each Section
Valve Type ................................................................................... Four Position - Raise, Hold, Lower and Float
Pump Capacity at 2200 Engine rpm ............................................................... 109 Litres/min (28.8 US gal/min)
Maximum System Pressure...................................................................................................206 bar (2988 psi)
Couplings................................................................................................ ISO and ASAE approved, Breakaway
Front Power Takeoff (If equipped)
PTO Type..............................................................................................................Independent of Transmission
Clutch Type ..........................................................................................................................Hydraulic Actuated
Rotation.................................................................................................Counterclockwise from Front of Tractor
Output Shaft Size..........................................................................6 Splines, 34.925 mm (1.375 inch) Diameter
PTO Speed ..........................................................................................................................................1000 rpm
Engine Speed for 1000 PTO Speed.....................................................................................................2200 rpm
IMPORTANT: DO NOT attach implements to the front PTO which need more than 74 kW to operate.
Rear Power Takeoff
PTO Type..............................................................................................................Independent of Transmission
Clutch Type....................................................................................................Multi Disc, Hydraulically Actuated
Rotation............................................................................................................. Clockwise from Rear of Tractor
Output Shaft Size,
540 rpm ........................................................................................................6 Splines, 34.925 mm Diameter
1000 rpm ....................................................................................................21 Splines, 34.925 mm Diameter
Output Shaft Torque,
540 rpm ......................................................................................................................... 2500 Nm (1844 lb ft)
1000 rpm ...................................................................................................................... 2500 Nm (1844 lb ft)
Engine Speed for Shiftable PTO (typically European/Rest of World Tractors)
540 PTO Speed ..............................................................................................................................1877 rpm
1000 PTO Speed ............................................................................................................................2200 rpm
Engine Speed for Reversible PTO (typically North American Tractors)
540 PTO Speed ..............................................................................................................................2163 rpm
1000 PTO Speed ............................................................................................................................2200 rpm