Instruments and Programming
81
4
Programming The Speed/Gear
Display Constants (Menu 11)
The following menu is used to inform the cluster
which transmission option is installed, either
Powershift or AutoSpeed. This will then allow the
correct speed/gear to be displayed; ie via the
cluster on a Powershift transmission or via the
multi-control lever on a AutoSpeed transmission.
IMPORTANT: Although these constants can be
viewed by the operator, the operator must NOT
change any of the current values as this may
affect the correct operation of the tractor. If
however it is necessary to change the
constants the following procedure should only
be carried out by your dealer.
STEP 1
STEP 2
STEP 3
Momentarily press the menu button
to enter the menu.
Use the UP and Down buttons to input
the new constant.
Refer to the following table for the
correct constants to input into the
cluster.
Transmission Type Constant
Powershift Transmission 1
AutoSpeed Transmission 0
Momentarily press the menu button to
store the new constant and return to
the main menu.
To Next Page
Loading...
