www.mdcusa.com
Ph: 1-833-632-8721
©Copyri ght
How to Hitch your coupler
The following steps outline how to safely use your coupler to couple and uncouple the trailer from the towing vehicle.
Preparation
Make sure the handbrake is applied prior to coupling and uncoupling.
Make sure the dust cap is securely connected to the bump cover. This is done by locating the rear lip on the dust cap onto
the groove of the bump cover and then pushing it in a downward motion until the dust cover is secure (there should be a
slight click when it has been assembled correctly) Test if the dust cover is connected to the bump cover by applying a
slight upward force to the dust cover, it shouldn’t separate.
This procedure should be applied if you are uncoupling or coupling up.
To Next Page
Loading...
