www.mdcusa.com
Ph: 1-833-632-8721
©Copyri ght
TV Antenna
All MDC travel trailers are factory fitted with a Milenco POWER
900L omnidirectional antenna. This antenna comes fitted with a high-
gain, low noise amplifier which is pre-wired to all the TV antenna F-
type outlets throughout the trailer.
Omnidirectional TV antennas do not require rotating to obtain a TV
signal, their radiation pattern allows them to receive
high-quality
reception from all angles without the need to locate the closest signal
source. To use the Milenco Power 900L, there are 3 steps:
1. Supply 12V power to the amplifier and TV, by switching on the DC
OUTLETS on the distribution switchboard of the trailer.
2. Make sure the TV is connected to any F-Type outlet in the trailer.
3. Run a channel scan on the TV.
If there are local terrestrial signals (DVB-T, ISDB-T, DMB-T/H, ATSC) or
AM radios, the antenna will receive them.
Run channel scan if the trailer has moved to a new location since previous use, as the new location will
have difference reception/signals available.
To Next Page
Loading...
