www.mdcusa.com
Ph: 1-833-632-8721
©Copyri ght
Selecting the Fresh Water Tank
The tank selector valves allow you to control which fresh water tank supplies
the system.
• The valves are located beside the water pump inside the trailer.
• To switch tanks, open the valve for the desired tank and close the valve for
the unused tank.
• This manual selection ensures optimal control over water use and tank
balance.
City Water Inlet
The city water inlet allows direct connection to an external water supply
without using the fresh water tanks.
• Located in the wet bay, the city water inlet features a standard threaded
connection for an RV drinking water hose.
• When connected, the system bypasses the water pump and pressurizes
the system using external water pressure.
• The inlet assembly features an integrated water pressure regulator to
prevent damage from high-pressure sources.
Always use a
potable water-rated hose
and regulator
when connecting to city water.
Grey Water Tank
The grey water tank collects wastewater from sinks and showers,
preventing it from discharging onto the ground.
• The grey water drain valve is located underneath the trailer for
easy access.
• To empty the grey water tank:
1. Position the trailer nearby an approved dump station.
2. Attach a suitable hose to the grey water outlet.
3. Open the grey tank drain valve to release wastewater.
4. Close the valve securely after draining.
Grey Tank Flush System
The grey tank flush inlet is located on the rear wall of the trailer and allows for internal flushing
of the grey water tank.
• To use:
1. Connect a clean water hose to the grey tank flush inlet.
2. Run water through the system to rinse out debris and residue.
3. Drain the grey tank completely.
Never use the same hose for drinking water and grey tank flushing.
Drawbar Tap
The drawbar-mounted tap provides external access to fresh water without
entering the trailer.
• It is connected to the fresh water system, allowing easy access for washing
hands, rinsing equipment, or filling containers.
• Ensure the water pump is on or that an external water supply is connected to
use the tap.
• The tap uses a standard ¾-inch BSP size thread.
To Next Page
Loading...
