www.mdcusa.com
Ph: 1-833-632-8721
©Copyri ght
Unable to record
Check an SD card is inserted and in the correct orientation
Make sure the SD card being used as been formatted before use
SD card storage may be full
excessive glare
The monitor comes supplied an Anti-glare screen and a screen protector. Make sure the
screen protector has been removed before use.
Connectivity
issues
such as
image lag,
dropping out,
excessive
pixelization
1. Make sure the caravan tail/parking lights are ON
2. Make sure the monitor is plugged into a live 12V socket
3. Check camera is paired with the monitor (see above)
4. Make sure supplied antenna is screwed firmly into the monitor screen
5. Uncoil the power cable of the monitor – this may cause electromagnetic interference
6. If still unsatisfactory contact MDC (warranty team to escalate to MDC compliance
Table 4
For more information, refer to the camera system instruction manual provided.
Disclaimer:
External impacts such as interference, power lines, speed of travel and weather
may affect the range, responsiveness, and visibility of the device. As such never use the camera solely and always actively observe your
surroundings. This product has been added as an ADDITIONAL safety product and should never be used as a substitution for active
supervision. MDCUSA shall not be liable for any loss or damage from not following this and the details within the products instruction
manual.
Charging the Caravan
Grid Power
Your RV charges from shore power via the Renogy REGO 12V 3000W HF Inverter Charger, which is directly wired to the
110V AC circuits in your RV. To charge using the multi-stage AC charger function of the REGO HF Inverter Charger:
1. Ensure the RV is connected to shore power via the externally mounted 110V power inlet, located on the offside of the RV.
2. Ensure the inverter charger is powered on using the Wired Remote Control or the On/Off/Remote Power Switch, located
on the
REGO unit itself.
3. Verify all necessary circuit protection is active:
o The Main Breakers (both located near the RV entry) must be in the ON position.
Note: Your RV is equipped with LiFePO4 (Lithium Iron Phosphate) battery, and the REGO HF Inverter Charger is factory-
configured for optimal charging of this battery type
Solar (PV) Power
The roof-mounted solar panels will automatically charge your RV’s battery system via the Renogy DCC50S MPPT/DC-DC
Combination Charger.
Note: Solar power output from the PV system will vary based on factors such as sun position, time of day and year, shading, and
UV intensity.
Towing Vehicle Charging
Your towing vehicle should be equipped with an Anderson plug connection to provide in-transit charging for your RV’s battery
system. This charge is managed and regulated by the
Renogy DCC50S DC-DC Charger while towing.
For further information and instruction see
Charging the Electrical System
section of this
manual or refer to the
supplied user manuals for each Renogy Appliance
To Next Page
Loading...
