6
1.2 Connecting and switching on
The TV set is now in standby mode and
the red standby indicator lights.
After about 25 seconds, the TV set swit-
ches to program position 1 or to the pro-
grammed initial program position (see
page 108).
If you press no further keys on the remote
control a window requesting that you do
so is displayed after about 10 minutes. If
you do not do this, the TV set switches
back to the standby state.
Switching on from the
Stand-by
Use the numeric keys to select any de-
sired program position. Pressing the
or TV key selects program position
1 or, if it is programmed, the initial pro-
gram position (see page 108.
Switching off
Press the key to switch the TV set to
standby mode. If you do not intend to use
the TV set for a longer period switch it off
with the main power switch.
2. Safety notes
• Always place the monitor on a solid,
stable surface.
• If a cold TV set is moved to a warm
room, always allow any condensation
on the screen to evaporate before swit-
ching it on.
• The TV set is intended for use in a dry
room. If, in exceptional circumstances,
you use it outdoors, take care that is
protected against moisture (rain, splas-
hed water, dew).
• Do not expose TV set to dripping or
splashes (e.g. rain)!
• TV sets need adequate ventilation.
Never cover the openings on the rear of
the set with curtains, doilies, newspa-
pers, etc.
Also take care that the slits in the bot-
tom of the case are freely accessible so
that the intake of the cooling air is not
hindered.
• If you place the TV set in a wall unit
leave sufficient space on all sides for
the circulation of cooling air.
• Do not place the TV set close to a radi-
ator, since this would effect adequate
cooling.
To Next Page
Loading...
