Metz Axio pro - Diseqc System

97
20.4 Set-up of satellite system
DiSEqC system
2)
Section 21.4 only in the case of correspon-
ding equipment or conversion.
“DiSEqC“ makes it possible to control the
satellite antenna digitally via the existing
antenna cable and is a prerequisite for the
reception of signals from more than two
satellites (e.g. Astra, Eutelsat, Hotbird).
If you wish to receive signals from at least three
satellites (e.g. ASTRA 19.2°, Eutelsat 16°, Hot-
bird 13°) the antenna system can be controlled
only with the aid of
“DiSEqC“.
This menu item is not
available in a 2**
menu.
Switching DiSEqC on and of
f
• Press the key to open
the TV menu.
• Press the red key to
open the menu “Configura-
tion“.
• Press the appropriate nume-
ric key (in this example
 to
select “DVB-S“.
• Press the button and the “Arial facility”
setup window opens.
• Use the cursor control buttons to select “DiSEqC”
and then use the V-/V+ button to set DiSEqC on
or off.
• Press the key to confirm the new setting.
• Press the key to close the TV menu.
☞
☞
i
Opening the menu
Antenna normal Power compensation off
LNB supply voltage off DiSEqC system off
General settings
Manual search
Automatic search
Hot Bird 13°
Astra 19,2°
Arial facility
Function for F2
Function for F1
EURO sockets
DVB-C
2)
DVB-T
2)
DVB-S
2)
Analog-TV
2)
Country
Language
Operating
Configuration
2) Possible only on sets equipped with this
function.
EXIT
MENU
